AP Installation Procedure
This blog explains the procedure and requirements to install a new AP in new coverage area. buy nexium generic https://noprescriptionbuyonlinerxx.net/nexium.html over the counter Site survey must be done prior AP installation to find the suitable location…
%SYS-4-CHUNKSIBLINGSEXCEED: Number of siblings in a chunk has gone above the thr
Issue : %SYS-4-CHUNKSIBLINGSEXCEED: Number of siblings in a chunk has gone above Cause : This is due to leaking within Crypto Request chunk. and to a commonly hit bug which can be viewed using by bug toolkit on CCO: CSCtw80533 Memory leak due to crypto_al…
Link pause (flow control) not enabled on back to back Nexus 5000 switch links
When link pause (flow control) is not enabled on back-to-back Nexus 5000 switch links, packets are dropped while sending traffic on a no-drop class. buy clomid generic https://rxxbuynoprescriptiononline.net/clomid.html over the counter ===================…
Traffic not queued or prioritized correctly on Nexus 2148, Nexus 2232, and Nexus 2248
After configuring all three types of policy maps (QoS, Network-QoS, and Queuing), the traffic is not queued or prioritized correctly on Nexus 2148, Nexus 2232, and Nexus 2248 switches. =================================================== Possible Cause The…
MTU for “class-default” value is 1500 when jumbo MTU configured
When the configuration for the network-qos policy-map sets the class-default to jumbo MTU, the show queuing interface command indicates that the MTU for class-default is 1500. ===================================================================== Possible …
Cannot pass frame size larger than 2300 bytes through switch
Although the jumbo MTU has been configured for class-default, you cannot pass a frame size larger than 2300 bytes through the Nexus 5000 switch and the Nexus 2000 FEX. ============================================================ Possible Cause The CoS val…
Licensing Installation Issues
Error Message: LICMGR-3-LOG_LIC_INVALID_HOSTID: Explanation: The feature has a license with an invalid license Host ID. This can happen if a supervisor module with licensed features for one system is installed on another system. Recommended Action: Reinst…
Unable to configure vPC
In this blog you will see the solution when you are configuring the VPC , the Nexus not allow to configure the vPC. Some of the possible cause has been discussed here : Possible Cause vPC is not enabled or is not supported in the NX-OS release of software…
intermittent network connection BGP/ Eigrp Routes issue.
Issue: intermittent network connection BGP/ Eigrp Routes issue. Temporary solution: – Both switches need to be rebooted each time issue occurred. Affected IOS used on both switch was: cat4500e-entservicesk9-mz. 122-53.SG.bin Fixes :- BUG: CSCsy92331…
VPN connectivity between dr-vpn01 and R01-VPN05 “EIGRP” is flapping
VPN connectivity between dr-vpn01 and R01-VPN05 “EIGRP” is flapping Solution : dr-vpn01(config)#interface GigabitEthernet0/0 dr-vpn01(config-if)#no crypto map MAP-TO-FO dr-vpn01(config-if)# crypto map MAP-TO-FO dr-vpn01#sh ip ei nei EIGRP-IPv4…