Smart Architecture has three tier system or has three components in it
Steps to access our lab
For example, if your mobile no. is +65 XXXX XXXX then +65 is country code and you can add 2 zeros in starting of the number to make it a 10 digit number i.e. 00XXX XXXXX
In the above lab( Checkpoint CCSA lab) shown:
Firstly to start working on the devices you first need to power on the device you want to operate, and power off as soon as you finish your task. Moreover, if you want to remove the previous configuration, right click on the device and erase the configuration of each device similarly so that the devices would come back on default setting.
Secondly, for operation your task you need to have your workbook too. So, for that you first need to go uninets.online.com and login yourself.
Then you need to go to my courses, here you will be able to see your workbooks. Go to Checkpoint CCSA workbook and you can operate you lab according to the task assigned in your workbook.
For instance, your first task assigned to you is to configure security management server (SMS) with hostname SM give IP-address to management interface 192.168.1.51/24 and took GUI from management interface with default credential and did remaining configuration.
Coming to our lab again we first need to login in our management server. Double on the management server, the window on which you can configure will open in a new tab. To start operating management server you need to login in first. For this you need to enter your username and password.
If you want to set host name to your device you can run command i.e. Set Hostname and then the name you want to assign. For example, Set Hostname SM, then if you want to save the configuration run command ‘Save Config’
Now we need to define IP address so that we can manage this device using a web console. Coming on to assigning IP address to this device run command Set interface eth0
Where, eth0 is your management interface by default or can be used to define in on an internal zone.
So, the command is Set interface eth0 ipv4-address 192.168.1.51 mas
Set interface eth0 ipv4-address 192.168.1.51 mask length 24
Finally the IP Address is defined now if you want to verify run command show interface eth0 and then enter. Now you will be able to see the IP address which has been defined.
Further, save the configuration y running command save config and try to access the management IP through a web console. So, for that you need to login with window server and assign the same IP address. Open the network setting of the device and run the command ncpa.cpl So. Open the network setting and we can check which IP address has been assigned, go to properties and its IP address is 192.168.1.101 but we need to change the gateway and DNS as well. Now we can access the web server through browser itself. Then on search panel type http://192.168.1.51 and then enter.
Get instructor-led training here: https://www.uninets.com/security/checkpoint-certifications/